|
|
|
 |
 |
 |
 |
 |
 |
sales@tru-volute.com |
|
|
1. Topping or semi-topping type cutters available. 2. Use of topping or semi-topping method facilitates size control of gears and prevents burrs from being produced at the corners of tooth tip, therebye minimizing failure and reducing cost. 3. Regrinding of the cutting edges can be made more easily than with hobs, and there are practically no chances of deterioration of accuracy. 4. Polygonal deviation of the gear tooth profile due to the generation is smaller than that by hobbing, and thus gears produced with a gear shaper cutter runs more smoothly than hobbed gears. |
| Home | Products | Specialty | Metrology | Location | Contact Us | Terms & Conditions Copyright
© 2003 Russell, Holbrook & Henderson, Inc. All Rights Reserved. |
